Re: S0C4 Abend in RELEASE Command
- From: eric-ibmmain@xxxxxxxxx (Eric Bielefeld)
- Date: 20 Mar 2008 11:22:44 -0700
Thanks John,
That was it. I figured it was something simple. The correct setc was commented, so I reversed the two.
Eric
---- John P Kalinich <jkalinic@xxxxxxx> wrote:
Eric Bielefeld of the IBM Mainframe Discussion List <IBM-MAIN@xxxxxxxxxxx>--
wrote on 03/20/2008 12:53:13 PM:
I am trying to use the RELEASE command with PDS86. I've used it in
the past to release extents, and release space from PDS's and leave
a certain amount of free space. I keep getting an S0C4 abend at
+X'364 into the module. This is the CBT version that comes in load
module format in file 035. I then downloaded the source from file
296 and assembled it with the exact same results.
Anyone have any ideas why this doesn't work?
Did you assemble with the following SETC? I think it defaults to something
else.
&MVSLEV SETC 'MVS220'
Regards,
John K
Eric Bielefeld
Systems Programmer
Aviva USA
Des Moines, Iowa
515-645-5153
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
.
- Prev by Date: Re: Convert EBCDIC to ASCII in batch?
- Next by Date: Re: Define Pagespace -- SWAP vs NOSWAP?
- Previous by thread: Re: S0C4 Abend in RELEASE Command
- Next by thread: testing
- Index(es):
Relevant Pages
|
