Re: Flashcopy on DS6800
Hi Guys,
We are due for a tape upgrade -- we have 3590-B1A drives, and the tape
backup starts after batch. It's slow enough that it doesn't finish in time for us
to bring test up until noon or so, thus the double flash.
Your input is interesting. I think we have a configuration issue which we need
to fix and then we are going to go to flashcopy=nocopy also.
Regards
Patty
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO
Search the archives at
http://bama.ua.edu/archives/ibm-main.html
.
Relevant Pages
- Re: Performance problems
... It might not make much difference if you have lots of extra capacity, but if you are constrained, even for relatively short periods of time (which may be difficult to detect with RMF), a good or bad WLM policy can make a big difference. ... RMF cpu intervals are 20% during the day and during the 3 hours of batch ... For IBM-MAIN subscribe / signoff / archive access instructions, ... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO ...
(bit.listserv.ibm-main) - Re: Performance problems
... One of the constraints you'll see is that IDMS can't write to the LOG file fast enough. ... A reduction in overall capacity will adversely affect IDMS's ability to respond to application calls, whether online or batch, in a timely manner. ... For IBM-MAIN subscribe / signoff / archive access instructions, ... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO ...
(bit.listserv.ibm-main) - Re: READPREV in batch
... the last record in a VSAM data set is issue the GET macro with the RPL ... Assembler in batch. ... For IBM-MAIN subscribe / signoff / archive access instructions, ... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO ...
(bit.listserv.ibm-main) - Re: OPERLOG search filter in batch
... SDSF can run in batch. ... For IBM-MAIN subscribe / signoff / archive access instructions, ... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO ...
(bit.listserv.ibm-main) - LE module CELHV002?
... I'm running a C++ program in batch. ... it is a program which reads information from a network connection ... For IBM-MAIN subscribe / signoff / archive access instructions, ... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO ...
(bit.listserv.ibm-main) |
|
