As far as I'm concerned, any command that an operator can issue should
be
in one manual!
As far as I'm concerned all commands should have a built-in help
facility similar to DEVSERV QDASD,? (although DEVSERV ? would be even
better).
Bob Shannon
Rocket Software
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
.
Re: Tape Retention - Permanent ... Can this parm apply to non CA-1 tape management system?...Bob Shannon wrote: ... For IBM-MAIN subscribe / signoff / archive access instructions,... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO... (bit.listserv.ibm-main)
Re: z9 Announcement ...>Bob Shannon wrote: ... The major news... For IBM-MAIN subscribe / signoff / archive access instructions,... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO... (bit.listserv.ibm-main)
RE: RSVNONR -DB2 ... I hope you're not implying IBM should invest resources to clean up APPC....Bob Shannon... For IBM-MAIN subscribe / signoff / archive access instructions,... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO... (bit.listserv.ibm-main)
Re: newbie qdasd question ... when I issue the console command DS QDASD,5B00 I receive the following ... IEE459I 14.41.05 DEVSERV QDASD 452 ... For IBM-MAIN subscribe / signoff / archive access instructions,... send email to listserv@xxxxxxxxxxx with the message: GET IBM-MAIN INFO... (bit.listserv.ibm-main)
