Re: Should'a gotten a light cycle

On Thu, 24 May 2007 09:05:44 +0200, Davide Bianchi
<davideyeahsure@xxxxxxxxxxxxxx> wrote:

naaa, you get the speed/rotation ratio set and that's about it. You
only need to tap into the same sensor that are already there for the
speedo and the rpm counter.

Shimano Flight Deck pushbike computers do almost exactly that, except
they're also the rpm and speed display units to start with so the sensors
don't even go to two places.

Except completely the other way round. It's got input from the gear
shifters that tell it which gear it's in, and a speedo sensor, and then it
derives rpm from there.

Jasper
.

Relevant Pages

  • Re: Intermittent Speedo
    ... Not sure if speedo is electronic or mechanical. ... They have a sensor on the gearbox which ... plastic gear which engages in the box. ... gearbox was loose on the shaft. ...
    (uk.rec.cars.maintenance)
  • Re: Intermittent Speedo
    ... Not sure if speedo is electronic or mechanical. ... They have a sensor on the gearbox which ... plastic gear which engages in the box. ... gearbox was loose on the shaft. ...
    (uk.rec.cars.maintenance)
  • Re: Intermittent Speedo
    ... Not sure if speedo is electronic or mechanical. ... I've had similar on Citroens. ... They have a sensor on the gearbox which sends ... Sometimes the gear can wear or the ...
    (uk.rec.cars.maintenance)
  • Re: slow tractor
    ... but there are some hits on american agricultural sites and one british ... Radar based speedo is AIR, ... one quad, again using a series of magnets and a sensor. ...
    (uk.business.agriculture)
  • Re: Speedo & Input Sensor
    ... >>> The speedo does not go all the way to 0 during stop and go ... >>> to change out the input sensor. ... The transmission doesn't use the distance ... an input speed sensor and an output speed sensor. ...
    (rec.autos.makers.chrysler)