Re: 700m laptop backlight fails after 1 min.




"John Vallelunga" <johnv@xxxxxxxxx> wrote in message
news:4817bbc1$0$34553$742ec2ed@xxxxxxxxxxxxxxxxx
My wife's 700m laptop backlight will light up when first turned on,
but then shuts down after 30-200 seconds. An external display works
fine. I assumed this was an inverter problem and bought a new one. I
replaced it today, but the problem remains. And yes, all the
connectors seem to be solid.

After some research, others have suggested the lid-closure switch
could be the culprit, but this switch seems to be working just fine.
I can boot to the bios and see the backlight come on and off as I
activate the switch (this assumes I do it within the 30-200 seconds
that it works.)

Two questions:
1. Can a bad backlight tube cause this problem? It seems to work
fine, and has normal brightness when it works. Could it be taking too
much current which makes the inverter stop working? Could it require
more voltage once it warms up? Any chance that replacing the tube will
help?

2. Any other ideas or suggestions?
Thanks, JV

A friend had an Inspiron 3800 with those symptoms.
He got the tube replaced and it fixed it.

Eric

--
Remove the dross to contact me directly


.



Relevant Pages

  • Re: 700m laptop backlight fails after 1 min.
    ... An external display works fine. ... I assumed this was an inverter problem and bought a new one. ... After some research, others have suggested the lid-closure switch could be the culprit, but this switch seems to be working just fine. ... Replacing the motherboard was what fixed it, not the LCD, not the cable. ...
    (alt.sys.pc-clone.dell)
  • Re: Blackout switch matrix problem
    ... The 40 pin connector between the ... I'm working on a switch matrix problem on a Williams Blackout. ... The system 3 through 7 driver boards are basically the same with minor ... some jumper wires replacing resistors in the switch inputs) so pretty much no ...
    (rec.games.pinball)
  • Re: NAP PTV300 Chassis Interchange?
    ... tube that comes out at an angle that the HV line slips into and a nut ... Since the set I bought came with the HV line and splitter, ... The O-rings between the lens and the cooling chamber are quite durable ... CRT and cooling chamber except on the rare occasion of replacing a ...
    (sci.electronics.repair)
  • Re: F-14 SIP resistor network? or transistor?or faulty diode or short in the white/brown wire st
    ... I think I would be replacing them just for the sake ... So I seperated that switch under the sling ... Every time one of the other switches tilts the machine, ... from the right flasher on the row of back flashers, ...
    (rec.games.pinball)
  • Re: F-14 SIP resistor network? or transistor?or faulty diode or short in the white/brown wire st
    ... I think I would be replacing them just for the sake ... So I seperated that switch under the sling ... Every time one of the other switches tilts the machine, ... Look for either a diode shorted to a coil or switch frame or a bent switch ...
    (rec.games.pinball)