Re: Thumb Drive

In article <I4KdndRIvNscyPrZnZ2dnUVZ8s6dnZ2d@xxxxxx>, 333@
999btinternet.com says...

"Jan" <myredsunfire@xxxxxxx> wrote in message
news:MPG.1ed0e69d2c1ca198989740@xxxxxxxxxxx
Hi all - I have a Dimension 4600 with an HP 1610 PSC with built in card
readers. I purchased a USB 2.0 flash drive and when I first plugged it
into a USB port, windows did it's routine of found new hardware, etc.
However, when I go into windows explorer I see "E" drive which obviously
is for the card readers in my printer and which I use with no problems.
But no new drive letter for the flash drive. Am I doing something wrong.
I would have thought the flash drive would have shown up as a new drive
letter, presumably F. TIA.
--

Cheers!

Jan

card readers in my comp only show a drive letter when they have a card
plugged in, are you sure the E has not been given to the USB flash.



When I click on E it says there is no disk in the drive. Putting a
memory card in the printer and then click on E shows the contents of the
memory card.
.

Relevant Pages