Re: Hard Disk, Cable
- From: "Mike" <Mike@xxxxxxxxxx>
- Date: Fri, 7 Apr 2006 17:46:19 -0700
Leaving the side off for awhile won't hurt anything. Even if gets dusty in
there you can just clean it (vacuum with/without dusting brush and EXTREME
care) before you seal it back up. Newegg should have right angle cables and
adapters. If I remember right, the last motherboard I bought had some of
those adapters in the parts pack.
-Mike
"journey" <jrny_of_life@xxxxxxxxxxx> wrote in message
news:v6vd32pq1gs5gu9fqns49o3p7p4gfbb5l9@xxxxxxxxxx
I installed the hard drive that others here responded about.
Everything is good -- the drive is installed, and right now I'm
formatting it using Disk Management.
When I went to put the case on I was having a very hard time and found
out that the data connection to the new hard drive goes straight out,
but the existing drive's connection is at a right angle. It was
preventing the case from closing.
So, I need a SATA cable with a right angle connector. Does anyone
know if there is an adapter to turn it into a right angle one?
Probably better to get a new cable.
What are the dangers if any of leaving the right side of the case
open. It's protected so nothing will bump into it.
Thanks
Journey
.
- References:
- Hard Disk, Cable
- From: journey
- Hard Disk, Cable
- Prev by Date: Re: Windows XP Sound Drivers for XPS 400?
- Next by Date: Sending Video from PC to TV
- Previous by thread: Hard Disk, Cable
- Next by thread: Re: Hard Disk, Cable
- Index(es):
Relevant Pages
|