Re: Dell Inspiron runs hot--normal

How do I ascertain the temperature

MB
"Fred Mau" <fred-dot-mau@xxxxxxxxxxx> wrote in message
news:Xns96DCC4E93F8FFfreddotmaucomcastnet@xxxxxxxxxxxxxxxxx
> "MZB" <moo@xxxxxxxxxxxxxxxxx> wrote in news:rUFZe.9756$eH2.6201@xxxxxxxx:
>
>> I assume it is, but just checking.
>>
>> When running more than 10 minutes, the bottom is hot.
>>
>> AC adapter also gets very hot when plugged in for more than ten minutes.
>>
>> I have an Inspiron 2200
>>
>> Mel
>>
>>
>
> Most laptops do run hot on the bottom and especially near the hard drives
> and CPU, 40 to 45c is not unusual (104 to 113F).
>
> The point to worry is when it gets up around 60c, then you start
> deteriorating the hard drive plus other components.
>
> - FM -


.

Relevant Pages

  • Re: XP Home, how can I make C: swappable
    ... >> My reply is at the bottom of your sent message: ... >>> Ideally I'd like to install XP Home on Computer 1, ... >>> swap these hard drives back and forth between the boxes at will. ... there to observe and to draw inferences from our observations." ...
    (microsoft.public.windowsxp.general)
  • Re: Mashing In a Metal Pot
    ... the temperature was at least 10F different from the bottom and top of the pot. ... I kept the burner on very low heat, and the average temperature of the mash stayed pretty constant. ... I'm not happy with the extremes on the top and bottom. ...
    (rec.crafts.brewing)
  • Ansys Static Thermal Problem (probably with loads)
    ... The model consists of the bulk silicon, ... oxide layer, nitride layer, some platinum strips, another oxide layer ... convection on the bottom of the silicon bulk and top of the last ... simulation I do get the temperature gradient, ...
    (sci.engr.analysis)
  • Re: ToshibaSatellite P15-S409, HDD Replacement
    ... all of those you have to remove the system board from the case to be ... :>> the hard drives at all. ... Most notebooks have compartments on the bottom ...
    (comp.sys.laptops)
  • Re: Mashing In a Metal Pot
    ... temperature of the mash stayed pretty constant. ... with the extremes on the top and bottom. ... typically have a big metal pot, with flame from underneath, right? ... A direct heated mash usually requires lots and lots of stirring in order ...
    (rec.crafts.brewing)