How to open Inspiron 8200 to add memory?

I'm trying to add some memory to my Inspiron 8200 and I can't get the
door off to the memory area.

Have one screw out and the other one is loose against a spring of some
kind. I try to lift the door out but something is still holding it
down. I don't want to force it.

Thanks for any advice.

Bill

.

Relevant Pages

  • Re: How to open Inspiron 8200 to add memory?
    ... > door off to the memory area. ... I try to lift the door out but something is still holding it ... there is only one screw holding that cover on and it is on the ...
    (alt.sys.pc-clone.dell)
  • Re: Best way to repair a solid front door
    ... I'm assuming from your descriptions that the door is composed of stiles ... Being as old as its age suggests, if you split the crack ... One would hope that you could apply glue and piece it back together ... Gently pry the crack open with a screw driver, if you can, so as to get the ...
    (rec.woodworking)
  • Re: 1997 LHS Alarm and Electrical issues...
    ... Unfortunately, I can't provided any further advice here, as you are further ... Once that was free the new one went into place in a matter of seconds before I had to spend another hour getting the screw and heat adapter back into place. ... Yesterday I put all of the seats back in but for the front passenger and today I put the dash back together, finally, 3 weeks after tearing it apart when I started his adventure. ... The driver door seems dead and I can hear the rear passenger door latch just spin when I push on the electric lock switch. ...
    (rec.autos.makers.chrysler)
  • Re: Door panel removal- how?
    ... Look for a screw in the lever that opens the door (in the plastic under ... the lever) and then look at the bottom of the arm rest. ... Also, if there is a 'cup' in the armrest used to close the door, look at ... Safety glasses are particularly recommended for this method, as the clip ...
    (rec.autos.makers.honda)
  • Re: question on garage door opener
    ... These garage door screws look like two-start, 1/8" pitch and so to pull on ... the nut and make the motor shaft turn as a result, ... I think the only way you could manually make the door move when the screw ...
    (alt.home.repair)