2-wire firewolf blinking



Hi. I have a 2-wire firewolf that blinks green on those two LEDs
every few seconds... but then it blinks red a couple of times, then
goes back to green.
I've searched for this in the manual with no luck. I even took it
down and tried to blow anything out of it with a bit of compressed
air, no luck. Is it defective?
Thanks much.
.



Relevant Pages

  • Avnet V2Pro dev board "Hello world"
    ... I haven't had any luck yet. ... any such simple code which works the LEDs on this board? ... -- entity to allow mapping my names to their names and using their ucf file ... component IOBUF port ...
    (comp.arch.fpga)
  • Re: Help! Color Changing LED Not Changing Color
    ... I already tried a 1, 10, and 100uf cap ... with no luck. ... The LEDs are inside of Robby, difficult to get to, so I ...
    (rec.games.pinball)
  • Re: Mains LED
    ... >> Good luck! ... It is something we overlook. ... I'd just use that small transformer I pulled out of a clock radio. ... a simpler solution may be to do away with the LEDs. ...
    (sci.electronics.design)
  • Re: FS: HUO BDK
    ...  Good luck though! ... LEDs make it worth less...cuz the buyer has to spend all that time ...
    (rec.games.pinball)