Re: Ademco Vista 20 X10 programming question

Bob Sisson wrote:
Ok... I got that... in what section.. with what code...

I saw something in *80 where I would uses a triggering event and identify a zone... but it didn't finish the idea...

I can use *80 to say Output function is triggering event (E)
Activated by Zone Number
Output is X10 (*79 stuff)

The Output Action makes no sense for X10... and I am not sure what address would be output (I do know what Housecode though)

Again... for Zone 15 what do I need to set to send a X10 when it faults...

You may think its easy...but it baffles me...I can program the alarm zone stuff, and the X10 automation stuff in my automation controler, but the X10 stuff in the alarm controller makes no sense to me...


A relay does one of two things,

It is open and then closes, or it is closed and then opens. duration is negotiable.

X-10 the same thing on or off.

Sorry if I can't be more help, but I don't have a manual here with me right now... anyone?... anyone?...

Once you identify the event you have to tell it what you want the relay to do (open or close and for how long).
.

Relevant Pages

  • Re: Ademco Vista 20 X10 programming question
    ... I saw something in *80 where I would uses a triggering event and identify a zone... ... The Output Action makes no sense for X10... ... You may think its easy...but it baffles me...I can program the alarm zone stuff, and the X10 automation stuff in my automation controler, but the X10 stuff in the alarm controller makes no sense to me... ...
    (alt.security.alarms)
  • Re: Ademco Vista 20 X10 programming question
    ... I can use *80 to say Output function is triggering event ... Activated by Zone Number ... The Output Action makes no sense for X10... ... stuff, and the X10 automation stuff in my automation controler, but the X10 ...
    (alt.security.alarms)