Re: DCS 832 & LCD5501Z zones

Max wrote:
This may be a dumb question but how do you program a zone off a
keypad? The manual says to *8(installers code) 020 then zone numbers
coresponding to the slot position of the keypad. When I do this the
LCD5501Z displays attribut numbers but the additional zones will not
program?? I am using 8 zones off of the panal and am trying to assign
zone 9 ans 10 to two of the 4 keypads I have


Thanks

You need to know the keypad address, 1 thru 8. Assuming your keypads are
addressed 1 thru 4, and you want to program zone 9 on keypad 1, and zone 10
on keypad 2:

*8 <installer code> 020 09 10 ##

--
js

- The bigger they are, the harder they fall.
( Also, the harder they bite, punch, and kick.)


.

Relevant Pages

  • DCS 832 & LCD5501Z zones
    ... This may be a dumb question but how do you program a zone off a ... The manual says to *8020 then zone numbers ... coresponding to the slot position of the keypad. ...
    (alt.security.alarms)
  • Re: Cheat sheet for Ademco Vista 20-P installation
    ... There are no dip switches on a 6160RF keypad. ... reading and web research I was able to program the panel to my liking. ... alarm installers time in setting up a new Vista system. ... Zone 1 MUST have an EOL resistor installed. ...
    (alt.security.alarms)
  • Cheat sheet for Ademco Vista 20-P installation
    ... Fellow Do-it-yourself Home Security System Installers, ... alarm installers time in setting up a new Vista system. ... Zone 1 MUST have an EOL resistor installed. ... I recommend the 6160RF keypad as it is alphanumeric AND it provides ...
    (alt.security.alarms)
  • Re: looking for an installer in St. Pete/Tampa area?
    ... There is a device called a PCI-MINI that plugs into a port on the Napco control panel and connects to the serial port on your laptop. ... You would make a list of what is connected to each "zone" on the panel similar to this: ... A sequence of screens comes up where you select things like the model of your panel, the number of keypads you're using, time delays for entry and exit, etc. ... If there is more than one keypad you have to set the address of the 2nd, third, etc. ...
    (alt.security.alarms)
  • Re: DSC Power832
    ... keypad manual and programming worksheet. ... Zone 02 - Read Door ... you'll want to reset the installer and master codes. ...
    (alt.security.alarms)