Re: Moose Z1100 Dialing Problem

I figured out how to read back what was programmed. (Close the
programming switch, hit 0 after power up, then a 3-digit address.
From there, hit pound and it will sequence through the addresses.
The 8 LEDs give the programmed value in binary as the manual
describes.) It appears that there are no telephone numbers
programmed, and it is just picking up and doing nothing. I did not
have a chance to reprogram, but I did read all the values and will
try to do a factory reset and then reprogram. I need to do the reset
because the programming code was overwritten somewhere along the path.

Thanks for the help.

Jim wrote:

Well, the zones could be programed to report on alarm but the panel
isn't programmed with a telephone number or account number.

It would pick up and do nothing.

--
Message posted via HomeKB.com
http://www.homekb.com/Uwe/Forums.aspx/security-alarms/200708/1

.

Relevant Pages