Re: XL2

1. Power down panel
2. Place a jumper on JP1 & JP2
3. Power up with AC only, wait 15 seconds
4. Power down, remove jumper
5. Power up, system should be defaulted.

This procedure will not remove CSID if you plan to download. Most times it is left default anyway.

If you still cannot get into programming, at least the user codes will be wiped clean.

Jim Rojas



Crash Gordon wrote:
Howdyall

Hey, on an XL2 if you don't know the installer code I forgot how to get it out or reset it..is it the same as Ademco stuff?

Gotta do a preinstalled apartment system tomorrow for a client of ours.


.

Relevant Pages

  • Re: Napco Gemini P800
    ... The ATMEL chip sounds right, ... Did you try defaulting the panel? ... Power down panel ... Place a jumper from terminal 3 & PGM ...
    (alt.security.alarms)
  • Re: XL2
    ... Power down panel ... Power up with AC only, ... Power down, remove jumper ... |> Gotta do a preinstalled apartment system tomorrow for a client of ours. ...
    (alt.security.alarms)
  • Infinite Crisis Issue Two Annotations.
    ... There are spoilers for issue two of Infinite Crisis here. ... page 17, panel one.) ... The Flash of Two Earths cover image. ... Animal Man has the power to absorb the powers ...
    (rec.arts.comics.dc.universe)
  • Re: Infinite Crisis Issue Two Annotations.
    ... There are spoilers for issue two of Infinite Crisis here. ... page 17, panel one.) ... The Flash of Two Earths cover image. ... Animal Man has the power to absorb the powers ...
    (rec.arts.comics.dc.universe)
  • Re: to clear CMOS
    ... Now that the jumper is in the 'clear CMOS' pins, for how long should I power up the computer before shutting down to replace the jumper to its original position? ... I might remove the CR2032 battery from its ...
    (microsoft.public.windowsxp.hardware)