Re: Power 632 and Motion

You'll not get an accurate resistance reading measuring it with the motion
relay wires connected to the panel..remove them and read it from the wires.


"Bob Smith" <bob@xxxxxxx> wrote in message
news:460d12d2$0$28131$4c368faf@xxxxxxxxxxxxxxxxx
|I have beating my head againts the wall trying to figure this out. I have
a
| Power632 and a DSC Pet Immune PIR hooked up to Zone 2.
|
| I have zone 2 set to zone type [04] which is said to be an interior in the
| manual. When I put a ohm meter up to the common and zone 2 pins on the
| alarm witht he motion hooked u I get .00 with the meter set to 200 ohms
and
| then when someone walks in front of it the ohm meter spikes. This tells
me
| the motion sensor is working correctly as a closed circuit. The problem
is
| that the alarm panel says that zone 2 is open all the time, no mater if
the
| motion sensor is on or off. If I short out zone 2 with the commom with a
| resistor it shows on the panel that the zone is closed.
|
| What am I missing here?
|
| Thanks!
|


.

Relevant Pages

  • Re: Ademco 998PI - detects motion but no alarm
    ... Yes...you'll need to program that motion detector into the system on ... whatever zone you wired it to in the panel. ... installer code and keypad that can get into zone programming (the cheap ...
    (alt.security.alarms)
  • Re: NAPCO 1008LK - programming
    ... I can't seem to turn off the motion detection without unplugging the ... When you walk past the motions and the keypads beep, ... the keypad beep when you open and close a zone. ... You can bypass each of the motion detectors by pushing the B / 0 key ...
    (alt.security.alarms)
  • Re: Vista 20 and IR motion problem
    ... Connect the two power wires to the motion ... Conect the hi zone to the NC terminal on the motion ... power terminals in the motion together. ... This LO is shared to the next zone which is unused so It ...
    (alt.security.alarms)
  • Re: Dammit.. How to get 2 zones and power from a 4-conductor
    ... negative are the same so you can use the power -ve at the motion for the ... zone common. ... But the problem is how to hook up the tampers at the panel ... I only have one extra zone. ...
    (alt.security.alarms)
  • Re: Datalogger to Test False Alarms on Sensor
    ... >> What alarm panel is the motion sensor connectd to?? ... You don't need a data logger. ... the zone to an unused partition with no siren output. ... Bass Home Electronics ...
    (alt.security.alarms)