Re: Napco MA3000 - Dialer Test on both Lines?

Good idea, but Napco doesn't allow open/close on telco line 2. I will check
with tech support Monday and let you know what I find.

"Frank Olson" <Use_the_email_links@xxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:0Wxug.194795$Mn5.53258@xxxxxxxxxxx
Allan Waghalter wrote:
Does anyone know how to get the MA3000 to send a daily test signal, as
required by NFPA, on both phone lines. No problem sending test on telco
1, just don't know how to make it test on telco 2. On our commercial
fire alarms, each line calls into a different account number and
different receiver for each line. We get no test on the second line.
Thanks,
Allan



Can you program openings and closings to dial on the second line? If so,
set up an auto-arm-auto-disarm window for the same time every day. This
should satisfy your "test" transmission requirements.


.

Relevant Pages

  • Re: Napco MA3000 - Dialer Test on both Lines?
    ... No problem sending test on telco 1, just don't know how to make it test on telco 2. ... You could set up a programmable Napco relay to interrupt phone line 1 from the panel, ... All the ULC communicators I work with have provision for only one daily test report, and that's typically on the primary line. ...
    (alt.security.alarms)
  • Re: Napco MA3000 - Dialer Test on both Lines?
    ... The CF5530 two line module for the Napco MA3000 selects the best working ... No problem sending test on telco ... just don't know how to make it test on telco 2. ...
    (alt.security.alarms)