Re: Scantronic 9800 bF every 5 minutes

You will need to open the main box, probably in the airing cupboard or
somewhere similar. You will trigger the tamper but you will be able to stop
sounders with your code. Replace battery and reset system. I would advise a
7Ah battery, it may be bigger than the one you have at the moment but it
will last longer in the case of power failure


--
Paul Ekins

Linc Secure
Ph: 0845 123 2599
paul@xxxxxxxxxxxxxxxx
www.lincsecure.co.uk


.

Relevant Pages

  • Re: Help - 1960s vintage quartz clock in need of repair
    ... >likely reason an old 1960's battery clock has stopped working. ... Resistor limits the current or to bias the transistor ... The triggering energy is done from one trigger winding that was ...
    (sci.electronics.repair)
  • Re: Help - 1960s vintage quartz clock in need of repair
    ... >>likely reason an old 1960's battery clock has stopped working. ... Resistor limits the current or to bias the transistor ... The triggering energy is done from one trigger winding that was ...
    (sci.electronics.repair)
  • Re: Latching Relay
    ... (battery driven), and that ultimately results in a high ... the relay is in operation and the mains powered device is on. ... Latching relay - I think these work by providing a brief trigger to ... but as my output is from 1 IC pin ...
    (sci.electronics.design)
  • Re: IED Detection - Whats the Latest
    ... Connect it across a battery with a couple of other bits and it free runs ... the frequency of each oscillator you encounter. ... probably launching an attack only every few weeks. ... try and use it as the trigger for an attack. ...
    (sci.military.naval)
  • Re: [acpi-jp 2879] 5.1R: page fault from AcpiNsMapHandleToNode
    ... > battery level is invalid. ... Parent pointer is invalid, as you show. ... sysctl after your system has booted: ... Then trigger the panic as described above. ...
    (freebsd-current)