Re: Powering off networx alarm security command panel?

I apologize for the rude response you received from what appears to be a
legitimate question from a novice. Your request is to simply power the unit
down. Quite easy.
1. Open the alarm panel (in the closet)
2. Locate the terminals marked "AC " below the telephone connection and
below the terminal marked "ground". Remove one of the wires from under the
terminal, not both, and put a piece of electrical tape on it to prevent it
from shorting anything else.
3. Locate the battery. It is big and looks somewhat like a small car
battery. Remove one lead, not both and your job is done. The alarm is dead
in the water.

If you can see where the panel's transformer is, you can unplug that from
the wall and avoid having to remove wires from the terminals themselves
(step 2).
Regards,
and have a good weekend!
Allan


<luvtopost@xxxxxxxxx> wrote in message
news:1152880557.518422.103940@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Not a troll. If you don't have a useful suggestion, then don't respond.
Stanley Barthfarkle wrote:
How do you power it off? There is no power button. I accidentally set
it on and can't get it to disarm, so when i open my door of house, it
goes off for like 10 minutes and i can't get it to stop on my own. The
alarm goes off, but the red armed light is blinking. I'm afraid to open
my door since it will go off again. I tried to go to the alarm speaker
to shut it off but can't pull the cover off the wall. It is tough. I
don't see a power button to shut off the Networx command panel. I don't
know why this is happening since i don't actually have service for this
security system. So how do i just power it off completely? Thanks a
bunch.


This one pegged my Troll-O-Meter... I think it's broken now.



.

Quantcast