Re: Programming Power632 for ContactID reporting

there is no auto cid in power 832,in power 864 yes..


"Mark Leuck" <m..leuck@xxxxxxxxxxx> a écrit dans le message de news:
PqWdnb9MtNNVPEDeRVn-rQ@xxxxxxxxxxxxxx
> Thats light 3, auto CID is light 7 and I never understood why DSC
> defaulted
> it to off in the first place
>
> "petem" <petem001@xxxxxxxxx> wrote in message
> news:FHdDf.9120$rX.135924@xxxxxxxxxxxxxxxxxxxxxx
>> Mark that would be true if it would be a sia system,but the OP is talking
>> about CID
>>
>>
>> "Mark Leuck" <m..leuck@xxxxxxxxxxx> a écrit dans le message de news:
>> xaSdnZOJx-edwEDeRVn-qg@xxxxxxxxxxxxxx
>> > Do NOT do it that way, it ends up being a bitch....
>> >
>> > Go to location 381 and turn light 7 off and it will all send correctly
>> >
>> > "Brandon" <bmbeck@xxxxxxxxx> wrote in message
>> > news:1138561549.500129.74830@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> >> Hi Jim,
>> >>
>> >> Thanks for the quick reply. In looking through the installer manual
>> >> it
>> >> seems like an A2 report code is an indication of "Fail to Report In"
>> >> which is under the Medical Alarm section. I'm getting this from page
>> >> 44 in "Appendix A: Reporting Codes" in a table called "Table2: Contact
>> >> ID Zone Alarm/Restoral Event Codes (as per ADEMCO)". Is this what you
>> >> intended or am I misinterpreting something?
>> >>
>> >> Assuming I'm just misinterpreting something and I do need to place an
>> >> A2 report code into each code I wish to get reports on could you give
>> >> me an example of how I would do that? I see in that same Appendix
>> >> that
>> >> section [320] is the Zone Alarms reporting code that is sent when a
>> >> zone goes into alarm. Am I just looking at punching in "*8 <installer
>> >> code> 302 *12" where the *1 is the HEX A. Or am I missing something?
>> >>
>> >> Thanks again for your help,
>> >> Brandon
>> >>
>> >
>> >
>>
>>
>
>


.

Relevant Pages

  • Re: Programming Power632 for ContactID reporting
    ... Thats light 3, auto CID is light 7 and I never understood why DSC defaulted ... >>> intended or am I misinterpreting something? ... >>> A2 report code into each code I wish to get reports on could you give ...
    (alt.security.alarms)
  • Re: DSC Wireless Smoke Reporting incorrectly
    ... Looks like I will have to turn off auto CID and put in all the ... reporting codes... ... Strange that DSC requires 87 or 88 for the zone type, ...
    (alt.security.alarms)