DSC PC1565

Anyone know how to get in to a PC1565 panel with installer lock-out ?

Just moved in to a house, with a PC1565 tried defaulting the panel, but it
seems it has the lock-out feature enabled and the security company that
installed it no longer exist.



.

Relevant Pages

  • Re: Voltage drop - panel or utility issue?
    ... homebuilder and did a lot of the improvements to the house himself. ... the lights in the room flickering just a bit at the same time. ... I decided I'd better get someone out here to look at the panel. ... and tightened down all the connections, and said everything looked OK as ...
    (alt.home.repair)
  • Re: Voltage drop - panel or utility issue?
    ... homebuilder and did a lot of the improvements to the house himself. ... the lights in the room flickering just a bit at the same time. ... I decided I'd better get someone out here to look at the panel. ... and tightened down all the connections, and said everything looked OK as ...
    (alt.home.repair)
  • Ademco Vista10-SE installing new 5808 problems?
    ... Bought my house a few months ago that had an old Vista 10-SE ... Then this week I bought a brand new 5808 in the box thinking I would ... Then today when I came home from lunch, the panel was giving the old "check" ...
    (alt.security.alarms)
  • Re: Scary Tingling
    ... main panel - whether it's the main panel of your house, ... the receptacle location I drove an 8 foot grounding rod into the ground ... unlike the ground connection in the house, it is not connected to neutral. ...
    (rec.outdoors.rv-travel)
  • Re: Increasing Electricity into your home question
    ... I bought a house which had a large 2-car garage below, and planned to use that full-time as my shop. ... He said I could put in a 400A service which split to two 200A panels, one to my existing panel, and I could pull the other 200A down to a subpanel in my shop, but I would have to have a disconnect outside at the service entrance so the firemen could shut off the power if they had to. ... the original 20 amps, I was going to pull with a smaller Welder. ...
    (rec.crafts.metalworking)