Re: Omega D2 Question
On Fri, 30 Sep 2005 18:09:35 -0700, Randall Ainsworth
<rag@xxxxxxxxxxxxxxxxxxx> wrote:
>It's been quite a few years since I had one, but there's a little
>adjustment with the screws that hold the head on. Other than that, it's
>only going to get so good.
>
True
Most enlargers leak light unless you take the extra step to seal it.
--
Colyn Goodson
http://www.colyngoodson.com
.
Relevant Pages
- Re: AO Spencer binocular head repair
... >> I recently purchased a used AO Spencer binocular compound microscope ... The interpupillary distance adjustment works smoothly, ... > My guess is that this is an AO 10 head, ... > remove the 4 screws that hold a plate where your nose goes. ...
(sci.techniques.microscopy) - Re: AO Spencer binocular head repair
... The interpupillary distance adjustment works smoothly, ... My guess is that this is an AO 10 head, ... replace the Bristol Splines with conventional screws. ... tension so it will slide back and forth but stop the eyepiece rocking you ...
(sci.techniques.microscopy) - Re: Seeking electronic earmuff recommendations
... Which model the rangemasters and you purchase... ... The last pair I got had no adjustment as to length over your head and the ... Prev by Date: ...
(rec.guns) - Re: Worst landing yet - maybe I wont solo!
... I walked through both patterns in my ... >> head about 6 times - every adjustment I could make, ... Prev by Date: ...
(rec.aviation.student) - Re: Omega D2 Question
... >>adjustment with the screws that hold the head on. ... > Most enlargers leak light unless you take the extra step to seal it. ...
(alt.photography) |
|
