copy image

I have 2 drives , the boot up C drive where I have winxp is about to fail I
hear it clicking.
my question is what program should i use to copy over my image over to my
other D drive so I can boot from it when my C drive fails so I dont have to
do a whole new install it willl take hours.

thank you in advance

Wizard


.

Relevant Pages

  • Re: how to change out system disk?
    ... Inaccessible_Boot_Device, when trying to boot from the new HD, but sometimes ... WinXP booted, you can still run Word, Quicken or whatever without having to ... following the primary partition and the first logical drive ). ... > logical drives in a single extended partition. ...
    (microsoft.public.windowsxp.hardware)
  • Re: Dual booting
    ... of Microsoft's dual boot scenario. ... The extended partition is not assigned a drive letter, ... BIOS reserves letters A and B for floppy drives, ... If WinXP Setup ...
    (microsoft.public.windowsxp.general)
  • Re: how to change out system disk?
    ... I wasn't able to get the system to boot to the new disk. ... logical drives in a single extended partition. ... > installed (Win2K and WinXP) should be in its own separate boot volume. ...
    (microsoft.public.windowsxp.hardware)
  • Re: FORMATTING C DRIVE
    ... How to do it is easy enough to answer and to do: Boot from the WinXP CD-ROM ... partition", ... Setup create Drives C: and D: and install WinXP. ...
    (microsoft.public.windowsxp.perform_maintain)
  • Re: no operating system upon boot
    ... setting a volume Active when you can't boot WinXP. ... and run FDISK to change the Active partition on your hard drive. ... >>> new install or format all drives and begin install... ...
    (microsoft.public.windowsxp.basics)