Re: Special ER32 Collet Nuts?
- From: jim <"sjedgingN0Sp"@m@mwt,net>
- Date: Mon, 25 Apr 2011 09:41:07 -0500
"J. Nielsen" wrote:
On Mon, 25 Apr 2011 10:11:42 -0400, "Joe AutoDrill" <autodrill@xxxxxxxx>
wrote:
I'm looking to stick four ER32 Spindles side-by-side with about 2.000" C-C
spacing in-line.
...Obviously, the standard nut and wrench are not really the best for this
set-up.
Anyone know of a solution or an alternate style collet nut?
There doesn't seem to be an ER32 "mini" nut available anywhere. Even a hex
would require a very unique socket set-up...
Drill two holes on the face of the collet nut to match the pins of a
face spanner wrench - perhaps use an adjustable face wrench.
That is what I was thinking. Also machine off the corners of the flats
if they are too big.
-jim
--.
-JN-
- References:
- Special ER32 Collet Nuts?
- From: Joe AutoDrill
- Re: Special ER32 Collet Nuts?
- From: J . Nielsen
- Special ER32 Collet Nuts?
- Prev by Date: Re: Special ER32 Collet Nuts?
- Next by Date: Re: Special ER32 Collet Nuts?
- Previous by thread: Re: Special ER32 Collet Nuts?
- Next by thread: Re: Special ER32 Collet Nuts?
- Index(es):
Relevant Pages
|
