Re: Chip extraction from tubular parts on CNC lathe

Garlicdude <pulsar@xxxxxxxxxx> wrote:

Robin, I also had to put a fine mesh filter on both lathes and mills. I was
surprised at how large a chip could get run through the coolant system.

We have some jobs where we take a bag filter to cover the coolant pump inlet to stop fines
and small chips from getting where they cause grief.

Wes
.

Relevant Pages

  • Re: Romney on green cards
    ... may create more jobs than they displace. ... ASML just bought Cymer, so you can now work for ASML in San Diego. ... The best science, engineering, and chip development are still being ... Google and Amazon are both impressive - but Google sees itself at the ...
    (sci.electronics.design)
  • Re: Jobs and Gates
    ... Steve Jobs played it very cool during the interview. ... that circa 1997 Microsoft were shoved into a corner by Apple ... is going to sue Microsoft's ass off, or Gates is keeping quiet ... downward spiral into the commodity (with a foreign Moto chip) abyss. ...
    (comp.sys.mac.advocacy)
  • Re: macAir CPU is non exclusive!
    ... putting together systems based on the special Core 2 Duo chip that Apple ... I'd say that Jobs got the dog and pony show from Intel, Jobs made a few suggestions, Intel executed those suggestions figuring it to be the best route for all. ...
    (comp.sys.mac.advocacy)
  • Re: macAir CPU is non exclusive!
    ... putting together systems based on the special Core 2 Duo chip that Apple ... I'd say that Jobs got the dog and pony show from Intel, Jobs made a few suggestions, Intel executed those suggestions figuring it to be the best route for all. ...
    (comp.sys.mac.advocacy)
  • Re: macAir CPU is non exclusive!
    ... putting together systems based on the special Core 2 Duo chip that Apple ... I'd say that Jobs got the dog and pony show from Intel, Jobs made a few suggestions, Intel executed those suggestions figuring it to be the best route for all. ...
    (comp.sys.mac.advocacy)