Matchining Paint?
- From: "Existential Angst" <UNfitcat@xxxxxxxxxxxxxxx>
- Date: Thu, 3 Dec 2009 14:07:38 -0500
Awl --
Yes indeedy, as in the matchining OF paint.
In Steve W's 12/2 response to my 12/1 thread DIY powder coating in rcm, he
sez:
You asked about spraying hot parts as well. YES you can do that and we
did that a lot on HEAVY cast parts or on parts where the customer needed
a specific thickness of coating for another purpose. For instance the
E-One company ( http://www.eone.com/sewer_systems/intro/index.htm ) had
us coating the pump housings and parts inside many of the sewage grinder
pumps they built. They wanted a VERY thick coat that would then get
machined flat and used as a gasketing surface. This kept all of the cast
iron housing covered and made those pumps last. To give them the proper
coat we would clean the parts and then pre-heat them up to cure
temperature. Then spray on the powder to build up the thickness.
In response to my response to the above, he sez:
They picked up that trick from one of our other customers. Small outfit
called GE Turbine Systems. We coated ALL of the shaft seals used on the
various turbines they made for about 10 years. In that case we used a
special powder that provided insulation properties for the shaft.
All very Kirk Gordon-ly. :)
--
EA, PV'd as usual, opting for effing spray paint...
.
- Follow-Ups:
- Re: Matchining Paint?
- From: Cliff
- Re: Matchining Paint?
- Prev by Date: Re: Climate skeptics are confused
- Next by Date: Re: OT: People are saying "depression"...
- Previous by thread: Re: Climate skeptics are confused
- Next by thread: Re: Matchining Paint?
- Index(es):
Relevant Pages
|
