Re: toolbox pictures
- From: Cliff <Clhuprich@xxxxxxx>
- Date: Fri, 12 Jun 2009 15:29:49 -0400
On Fri, 12 Jun 2009 14:11:13 -0400, "Jerry" <jzak@xxxxxxxxx> wrote:
You are going to get me in trouble.
I played low for a long time but so it happens we have few of those Chinese
Kurt knock-off vises.
Nobody ever uses them but this does not seem to make much difference.
Jerry
"Cliff" <Clhuprich@xxxxxxx> wrote in message
news:cmn135hfip231r07d4eon2el9iga6b8nqj@xxxxxxxxxx
On Thu, 11 Jun 2009 06:21:42 -0400, "Jerry" <jzak@xxxxxxxxx> wrote:
Yes I did.
That part may look nice on the outside but inside was even more
challenging.
The whole thing is hollowed out thru all those tubes using 6" long 0.5"
lollipop cutter.
0.03" to 0.09" walls with 0.001" to 0.005" tolerance all over.
I wish I could post few pictures and videos I took but I think it should
not
even be on this picture.
I will ask my boss today if it would be ok to share few photos.
Jerry
Pretty spiffy in any case.
jb eat your heart out.
Not a part for electroforming?
--
Cliff
.
- References:
- toolbox pictures
- From: Charlie Gary
- Re: toolbox pictures
- From: Jerry
- Re: toolbox pictures
- From: BottleBob
- Re: toolbox pictures
- From: Jerry
- Re: toolbox pictures
- From: Joe788
- Re: toolbox pictures
- From: Jerry
- Re: toolbox pictures
- From: Cliff
- Re: toolbox pictures
- From: Jerry
- toolbox pictures
- Prev by Date: Re: Computex 2009
- Next by Date: Re: toolbox pictures
- Previous by thread: Re: toolbox pictures
- Next by thread: Re: toolbox pictures
- Index(es):
Relevant Pages
|
Loading