Re: Obama wins

On Nov 9, 8:20 am, Wayne Weedon <wa...@xxxxxxxxxxxxxxx> wrote:

You sure did miss the whole point as usual. Perhaps this is because
you constantly have your head where the sun doesn't shine.

Freethinking is not your forte just admit it.

You choice in a CADCAM systems shows you're an idiot with no clues.

Why don't you admit that you just don't think period as the record
shows that not thinking is really what your forte is.

Sheep? Hm lets see XR3 has been out 6 months or more, when did I even
bother to try it? Last week is when, and that was only being inquisitive.

OneCNC XR2 was crap. OneCNC XR3 is crap. You made a choice to use crap
because you don't think and have your head where the sun doesn't
shine.

Sheep is perhaps the apparently millions who went with Mastercam ? I
looked at it (as I have stated numerous time before) Didn't like it, did
like the cost inc incidental/extra costs.

There hasn't been a lot of choice Weedwacker. 2009 will offer better
choices, even if most of those choices runs inside of SolidWorks it's
still far better than most of the lousy choices that have been
available.

Sheep those that follow you as Sheppard?

Close to 10,000 hits to the Jon Banquer Blog, many by those who are
trying to better understand their choices and don't program just 2
hours a week like you do.

The Jon Banquer blog is the most read independent CAM centric blog on
the Internet.

Jon Banquer
San Diego, CA
http://jonbanquer.blogspot.com/


.

Relevant Pages
Loading