Re: Better quality can be a bad thing....(long but important)
- From: brewertr@xxxxxxx
- Date: Tue, 05 Aug 2008 21:54:49 -0700
On Tue, 5 Aug 2008 18:32:10 -0700 (PDT), jon_banquer
<jon_banquer@xxxxxxxxx> wrote:
Give it a look, can't hurt. Its the gage above the oil resevoir.
Do you mean the gage above the way lube reservoir?
If so it's at zero on both machines and stays at zero even during a
tool change.
Jon Banquer
San Diego, CA
Did you try looking in the manual?
He said it was in the manual even told you where.
Tom
.
- Follow-Ups:
- Re: Better quality can be a bad thing....(long but important)
- From: jon_banquer
- Re: Better quality can be a bad thing....(long but important)
- References:
- Re: Better quality can be a bad thing....(long but important)
- From: kinzie
- Re: Better quality can be a bad thing....(long but important)
- From: larryrozer
- Re: Better quality can be a bad thing....(long but important)
- From: tnik
- Re: Better quality can be a bad thing....(long but important)
- From: jon_banquer
- Re: Better quality can be a bad thing....(long but important)
- From: vinny
- Re: Better quality can be a bad thing....(long but important)
- From: larryrozer
- Re: Better quality can be a bad thing....(long but important)
- From: brewertr
- Re: Better quality can be a bad thing....(long but important)
- From: jon_banquer
- Re: Better quality can be a bad thing....(long but important)
- Prev by Date: Energy breakthrough!
- Next by Date: Re: Questions That An Official OneCNC Crapware Shill Won't Answer
- Previous by thread: Re: Better quality can be a bad thing....(long but important)
- Next by thread: Re: Better quality can be a bad thing....(long but important)
- Index(es):
Relevant Pages
|
