Re: American Machinist Starts Evaluating CAM Software

On Jul 29, 6:32 pm, Garlicdude <pul...@xxxxxxxxxx> wrote:
American Machinist is starting their CAM software evaluation
series. The first link gives some tips on how to evaluate
software. the second link is to their first review which is
the Delcam family of products.

http://www.americanmachinist.com/304/Issue/Article/False/81476/Issue

http://www.americanmachinist.com/304/Issue/Article/False/81478/Issue

Best,
Steve

--

Regards,
Steve Saling
aka The Garlic Dude ©
Gilroy, CA
The Garlic Capital of The World

http://tinyurl.com/2avg58


Pretty close to worthless so far. No surprise there. American
Machinist is a worthless magazine.

While the following is quite old it does show the integration of NX
CAM with Solid Edge as well as quite a bit about UG NX CAM.

http://www.plm.automation.siemens.com/legacy/multimedia_cd/start.htm

Jon Banquer
San Diego, CA
http://jonbanquer.blogspot.com/

.