Re: Can I buy an answer?

On Fri, 07 Mar 2008 12:36:06 -0600, F. George McDuffee
<gmcduffee@xxxxxxxxxxxxxxxxxxxxxx> wrote:


FWIW - these drills had #2MT shanks. I still have 2 that I use
very seldom because of their odd size [27/64]. We had two drill

Tap drill for 1/2-13:-)
Got a drawer full of worn out stub length 27/64 Nachi Cobalt's. One of
these days I'll get a drill sharpener:-}

Matt
.

Relevant Pages

  • Re: Broken Water Pump Bolt on 5.0 Ford
    ... die, threading a nut halfway on, and welding the nut to the stub to ... If it's not *too* badly stuck the heat ... drill bit the same size as the hole or slightly smaller. ...
    (rec.autos.tech)
  • Re: Good News/Bad News
    ... the stub may not spin out even with the ... > Drill a hole in the bolt with a drill that is smaller than the root ... so you stop drilling when the hole size reaches ...
    (rec.bicycles.tech)
  • Re: Bugger, broken drill bit...
    ... only a tiny stub of the bit is sticking out. ... remove it without damaging the part? ... claims for using them with drill bits. ...
    (rec.crafts.metalworking)
  • Re: Removing frozen bolt
    ... Or am I going to have to carefully drill ... Carefully center punch the flat. ... Using a small drill, start a hole, and point the drill to correct any ... Drill through the broken stub, using increasingly larger drill bits, ...
    (rec.crafts.metalworking)
  • Re: Can I buy an answer?
    ... Got a drawer full of worn out stub length 27/64 Nachi Cobalt's. ... If you've got a pedestal grinder, disk sander, belt sander, or surface grinder, you've ALREADY GOT a drill sharpener, eh? ...
    (alt.machines.cnc)