Re: Rigid metric tapping

Bill Roberto wrote:
Proctologically Violated©® wrote:
Bill,

I think you owe me some taps. :)
And material. :) :)


What happened?

I think his taps went south on him Bill.
OTOH, you don't "owe" him anything.
Advice is worth what you pay for it <G>

SXXX.1 not Sxxx.2


--
John R. Carroll
www.machiningsolution.com


.

Relevant Pages

  • Re: Rigid metric tapping
    ... I think his taps went south on him Bill. ... OTOH, you don't "owe" him anything. ...
    (alt.machines.cnc)
  • Re: Rigid metric tapping
    ... I think his taps went south on him Bill. ... you don't "owe" him anything. ... I think that engages the high gear range on the high/low spindle. ... I was wondering if you can go from inch units to metrec units ...
    (alt.machines.cnc)
  • Re: Rigid metric tapping
    ... Stop Corruption in Congress & Send the Ultimate Message: ... Ending Corruption in Congress is the *Single Best Way* ... I think his taps went south on him Bill. ... you don't "owe" him anything. ...
    (alt.machines.cnc)
  • Re: Rigid metric tapping
    ... you don't "owe" him anything. ... Advice is worth what you pay for it ... I don't feel I owe him taps or material either. ...
    (alt.machines.cnc)