Re: Computer Notebooks On The Shop Floor

"I find it hard to believe that of the many thousands of Gibbs users
out there that they need to use NC-Plot to verify the G-Code they
produce with Gibbs."

Please post a link where I said "many thousands of Gibbs users need to
use NC-Plot".

What I said is something to the effect of: Check the Gibbs message
board and you will see that some Gibbs users use NC Plot. The reason
they do this is because Gibbs solid cut part rendering checks the
internal toolpath file not the actual G code. Perhaps you can try to
convince them that NC Plot is not needed because you can't convince me
of your opinion. I like NC Plot. It's a valuable tool for anyone who
wishes to check their actual G code output. If you don't like NC Plot
don't use it.

Jon Banquer
San Diego, CA





.