Re: Surfcam Post


"jerrjocnc" <jerrjocnc@xxxxxxxxxxx> wrote in message
news:g9WdnZEMr5mPDDzYnZ2dnUVZ_v2nnZ2d@xxxxxxxxxxxxxx
I have a problem with my Fadal post that I can't figure out. What I want
is
when I'm drilling, tapping, boring, etc, I want my Z to always move back
to
the rapid plane in Z, then XY to the next location. What is happening is
I
am getting my XY move to the next hole from the plunge plane. So if I
have
a wall with a hole on each side and I'm plunging to .100, I'll hit the
wall
moving to the next hole even though my rapid plane is well above the wall.
Any help would be appreciated. If needed I could send a copy of my post.


You would need to output a G98 along with the fixed cycle ( G81, G82, G83
etc. ) call....appears instead you are defaulting to G99

http://www.compumachine.com/Support/Downloads/Fadal/Quick%20Reference/0030__
Program_Codes.pdf

--






.