Re: haas peck taping


Anna, here you go::::

Depending on the age of your machine, you will have to do one of two
things,

1) Older machine, go to parameter 57 and make sure "REPT RIG TAP" is
switched to "1", if it is not, you will have to unlock the parameters
on the settings page, to change this, go to setting 7 and turn
parameter lock to "off" by toggling the right cursor arrow and hitting
enter after the cursor starts flashing, go back to the parameter page
and enter 1 on the REPT RIG TAP line, (you may have to e-stop the
machine to turn the servos off), go back to the settings page and turn
the parameter lock back on.

Disclaimer: Do not change any other parameter than REPT RIG TAP, that
is all I am instructing you to change and am not responsible for any
other changes you make!

2) Newer machine, go to setting 133 and toggle the right cursor arrow
and hit enter when the cursor starts to flash. (That is in the book)

Side note, it will not hurt the machine to leave rept rig tap turned
on.

Then all you have to do is re-tap to another depth in another line.

Example:
1 1/4-7 nc thread 2.00 deep

T1M06(1 1/4-7 TAP)
G00G80G90G54X0.Y0.
G43H1Z.1M8
G98G84R0.1Z-1.0F30.S210
G80
G84R0.1Z-2.0F30.
G80
G91G28Z0.
G90
M30

.