Re: Return tube for ballscrew

Hello,

The picture tube2.jpg have been updated. Yes I have tried to do one but
no good result. My big I have no time do to test.

I need 2 tubes.

Thanks

Eric

clutch@xxxxxxxxx a écrit :

"indiana95" <indiana95@xxxxxxxxx> wrote:

Hello,

I have a ballscrew who the return tube is domaged. If anyone can
do this kind of tube or need more informations just send me a e-mail :
indiana95 at yahoo dot com.

for specificaions:
Ball diameter: .124"
http://www.sabec.ca/tube1.jpg
http://www.sabec.ca/tube2.jpg

Eric

Have you thought about making one yourself?

It looks like you could make your own tubing fairly easily since it is
so short.

Bending it might be a bit tricky. I'd try filling the tube up with
solder to keep it from colapsing and then use / make some blocks to
bend it. Then heat it to get the solder out.

I couldn't tell from the fuzzy picture where the damage is. Try
posting a clearer picture and also post to rec.crafts.metalworking for
ideas.

Wes S

.