Re: Vise/Table Protection
- From: "Peter" <prenolds@xxxxxxxxx>
- Date: 8 Sep 2006 18:25:13 -0700
As I was writing my earlier note, the same thought occurred to me.
Just out of curiosity I'll order a piece of zinc and bolt it out of the
way on one side of the table. I'll post an update in a couple of weeks
if I notice any improvement (or not).
- Prev by Date: Re: Fadal Tool Setting Tid-Bit
- Next by Date: Re: anyone do hole boring?
- Previous by thread: Re: Vise/Table Protection
- Next by thread: Re: Vise/Table Protection