Re: Cutter Compensation question for Lathe

Michael,

Mori-Seiki and Traub multi turrets are the same way, makes them easer
to program, set up and operate.

That's how I knew Cliff is a fraud with his posted two line sample
G-Code with 5 mistakes in it. There is a reason Cliff has not been able
to post a Make, Model and Year for the CNC Lathe he says his "Standard"
Code will run on.

Tom

Michael Rainey wrote:

When I programmed twin-turret flatbed Okumas in the early eighties, G41 and
G42 for both turrets were determined as if you were cutting with the rear
turret - G42 for OD turning, G41 for boring. Circular interpolation G02/G03
the same - the rear turret ruled.

.