Re: Absolute Encoders

Check the backup batteries. He shouldn't have to do this from power outages.

ca

bborb wrote:
A buddy has several SuperMax mills with Fanuc OT controls. Different times,
usually from power outages, he has to hold in "P" and "CANCEL" at power-up
to get the machine to home at proper position, then he's fine. He actually
says he holds in 3 keys but I only remember "P" and "CANCEL". The problem is
he now has an identical homing problem with his SuperMax lathe which has a
Fanuc 10T control. Is there a similar procedure for the 10T to get the
machine to home back to original position?
Any help is appreciated,
Bart


.