Re: OT -motorcycle conundrum

ff wrote:
clay wrote:




Check the compression. .025 valve lash is ten times too much. Probably has a bent valve. Been there, done that.

Fred



Fred,

So I tried to set the valve lash to less. When I got to .015", I think the valve was hitting the piston as it came up. So it is something like that. or a dropped/loose seat, or junk under the valve. time to pull the head, I guess......darn

ca



Now is the time to add some aftermarket performance parts!

http://www.powroll.com/P_HONDA_XR100_79-00.htm

Fred


I know where this is going..reaaally bad suggestion!
ca
.

Relevant Pages

  • Re: valve train noise or worse ?
    ... > My car has had valves tightened a bit too much, ... I hear too much noise coming from the cover. ... The rockers are cast aluminium, ... > shafts, and even a camshaft, and adjust valve lash again. ...
    (rec.autos.tech)
  • Re: valve train noise or worse ?
    ... Is the valve lash correctly set? ... I hear too much noise coming from the cover. ... The rockers are cast aluminium, ...
    (rec.autos.tech)
  • Re: Tappet noise Virago xv750
    ... Turn the engine to TDC on the cylinder whose valves you want to check. ... The valve lash will be at maximum when both valves are closed at TDC. ...
    (rec.motorcycles.tech)
  • Re: To adjust hot or cold?
    ... Teggers was pointing out that valve lash should be adjusted when cold. ... If you adjust valve lash when cold, the valve has a chance of being burned because the tolerance you set will be reduced when operating temperature is reached and the valve may be open too long. ...
    (alt.autos.toyota)
  • Re: OT -motorcycle conundrum
    ... So I tried to set the valve lash to less. ... the valve was hitting the piston as it came up. ... did you really want to try hitting the trails on a holiday ...
    (alt.machines.cnc)