Re: What end-mill should I use ????


Cliff wrote:
On 19 May 2006 17:10:02 -0700, "Charlie Gary" <cgary@xxxxxxxxxxxxxx> wrote:

4FL

You'd use a 4 flute for trepanning?
Stock is 1/2 " ....


A 5 inch radius on the tool can be a major hurdle in a lot of tool
changers, so I assumed he was seeking a solution that would fit in a
normal end mill holder.

Later,

Charlie

.

Relevant Pages

  • Re: What end-mill should I use ????
    ... You'd use a 4 flute for trepanning? ... Stock is 1/2 " .... ... A 5 inch radius on the tool can be a major hurdle in a lot of tool ...
    (alt.machines.cnc)
  • Re: What end-mill should I use ????
    ... Cliff wrote: ... You'd use a 4 flute for trepanning? ... A 5 inch radius on the tool can be a major hurdle in a lot of tool ...
    (alt.machines.cnc)