Re: Mori Seki SL1 NC lathe programming

Cliff,

You can't jump to the middle until you complete the beginning. In
setting up and programming an SL-1 you need to know how to do a G50
first. You have to finish step one and two before you move to step 3.

It is obvious to me now that you have never programmed, setup or
operated a vintage CNC machine. You are way too use to controllers that
do everything for you that you don't even know the basics, quite
limiting for you but humorous for me.

You are good with catch phrases <JB> I'll give you that much. You are
among the best at baffling people with bullshit rather than dazzling
them with shine.

Tom

Cliff wrote:
On 29 Apr 2006 11:50:58 -0700, "brewertr" <brewertr@xxxxxxx> wrote:

Cliff wrote:
On 29 Apr 2006 11:42:24 -0700, "brewertr" <brewertr@xxxxxxx> wrote:

Cliff said,

"Using a G50 would still leave you programming that sharp corner
that's not there <G>. "

Cliff,

That is an incorrect.

Why do you think not?

Cliff,

Its in the code we generate for the machine.

What is? "Generate" how, exactly <G>?
--
Cliff

.

Relevant Pages

  • Re: Mori Seki SL1 NC lathe programming
    ... X axis reading + the OD diameter and the answer is your G50 X ... That's called "work surface programming" and the control must ... Some only know simple manual programming. ...
    (alt.machines.cnc)
  • Re: Fanuc 18i Daewoo Puma with live spindle and subspindle g-code proof read.
    ... I NEVER use G50--its simply not needed and hasnt been for nearly 35 ... most of the fanuc as well as the citizen programming examples use G50 quite ... G50 has two uses, we are not using it for programming zero, in our ...
    (alt.machines.cnc)
  • Re: Mori Seki SL1 NC lathe programming
    ... G50 is directly related to the center of the tool nose radius. ... programming to the "Theoretical Sharp Edge" which is incorrect and I ... First you need to explain step by step how you would calculate the G50 ... what with that magical invisible sharp corner .... ...
    (alt.machines.cnc)
  • Re: Mori Seki SL1 NC lathe programming
    ... "Using a G50 would still leave you programming that sharp corner ... Cliff wrote: ...
    (alt.machines.cnc)
  • Re: Mori Seki SL1 NC lathe programming
    ... You couldn't get past calculating Keith's G50 values so we never got to ... You assumed my programming and others who agreed with me ... change the TNR but keep the touch-off data the same. ...
    (alt.machines.cnc)