Re: new poll: Need yall's thoughts on a high speed graphite mill....
- From: J. Nielsen <morgan@xxxxxxxxxxxxx>
- Date: Sat, 10 Dec 2005 15:28:22 +0100
On Sat, 10 Dec 2005 06:06:39 -0500, "vinny" <friggenbozo@xxxxxxxxx> wrote:
>Can't keep doing this on a haas forever. The haas rounds edges on 90 deg
>sharp corners over 10-12 inches per minute. I'd like to run this stuff
>around 20-30 ipm. Is there mills out there that can move at that speed and
>not round edges?
Any difference if you put a *small* radii on the corners?
--
-JN-
.
- Follow-Ups:
- References:
- Prev by Date: Okuma DCN-4
- Next by Date: Schneeberger driver & servo repair work needed
- Previous by thread: new poll: Need yall's thoughts on a high speed graphite mill....
- Next by thread: Re: new poll: Need yall's thoughts on a high speed graphite mill....
- Index(es):
Relevant Pages
|
