Re: accurate bore



On Sun, 09 Oct 2005 10:53:09 -0500, William D. Green
<wgreen@xxxxxxxxxxx> wrote:

>You mill guys are two one dimensional! hehehehe

"tight tolerance bore, 2.375" -0.0000 +.0005."
What tolerance must be held on the OD?
--
Cliff

.



Relevant Pages

  • Re: Positional tolerance question
    ... Cliff wrote: ... >> And what do YOU think ANSI Y14.1 says is the tolerance for a three ... Prev by Date: ...
    (alt.machines.cnc)
  • Re: Positional tolerance question
    ... >Cliff wrote: ... >>>standards for the tolerance of three place decimals. ... tolerance that IS to be applied, IIRC, among other things. ... I actually wrote a small bit on tolerance "callouts" & standards ...
    (alt.machines.cnc)
  • Re: Positional tolerance question
    ... >Cliff wrote: ... >>> And what do YOU think ANSI Y14.1 says is the tolerance for a three ... >the standard tolerance for a three place decimal? ... IF it were covered by the ANSI Y14 series there would be ...
    (alt.machines.cnc)
  • Re: Positional tolerance question
    ... >Cliff wrote: ... >with my observation that there are no industry wide standards for the ... >tolerance of three place decimals. ...
    (alt.machines.cnc)
  • Re: Positional tolerance question
    ... >>Cliff wrote: ... >>> The later is often a general note, ... >>> tolerance that IS to be applied, IIRC, among other things. ... with my observation that there are no industry wide standards for the ...
    (alt.machines.cnc)