Re: Fadal Tool Changing Problem
- From: "Robin S." <lasernerd@xxxxxxxxxxx>
- Date: Wed, 17 Aug 2005 23:42:49 -0400
"Anthony" <tonytn36sp@xxxxxxxxxxx> wrote in message
> I've seen this same problem on all kinds of milling machines. As SVL
> said, most of the time a little grease on the tool holders cures it for a
> while. I don't think it's a taper mis-match problem as much as it is a
> 'perfect fit' for the taper. A little mis-match would make it easier to
> knock out. A perfect fit would lock tighter, and be more subseptable to
> 'seating' tighter. If you pay attention, i'll bet it is worse after a
> heavy vibration cut.
At work we manually spot every block into the dies before and after
hardening. I wonder if spotting blue (I think people call it Prussian blue
or something) would be thin enough to detect a "less good" tool holder...
- Prev by Date: Re: OT - "I am George W. Bush and I approve this mess."
- Next by Date: Re: Survey: Do You Leave a Toolholder in the Spindle Overnight?
- Previous by thread: Re: Fadal Tool Changing Problem
- Next by thread: Re: Fadal Tool Changing Problem