Re: Plasma Cutters???
- From: Gary <garyrin@xxxxxxxxx>
- Date: Fri, 05 Aug 2005 14:00:13 -0700
"F. George McDuffee" wrote:
> Downside is that plasma cutting is a dirty process [the metal has
> to go somewhere] that puts black dust everywhere.
Build a water table, it will pick up most of the slag and a lot of the smoke.
It only takes about half an inch of water located several inches below the
grate.
.
- References:
- Plasma Cutters???
- From: Jeniffer Ness
- Re: Plasma Cutters???
- From: F . George McDuffee
- Plasma Cutters???
- Prev by Date: Re: Haas floppy drive help.
- Next by Date: Delay circuit to switch servo driver and servo motor power supply ON and OFF ?
- Previous by thread: Re: Plasma Cutters???
- Next by thread: Dyna Mechtronics Single Phase Conversion
- Index(es):
