Re: Machining Slang
- From: "Proctologically Violated©®" <physical@xxxxxxxxx>
- Date: Fri, 29 Jul 2005 02:32:19 -0400
How bout, Polish This Knob...
----------------------------
Mr. P.V.'d
formerly Droll Troll
"BottleBob" <bottlbob@xxxxxxxxxxxxx> wrote in message
news:42E9A439.D4C78282@xxxxxxxxxxxxxxxx
> To All:
>
> Here should be a non confrontational thread that just about anyone can
> contribute to. What are some machining slang terms you use, or have
> heard of. Here are a couple to start this off:
>
> "Blow a hole." As in "Go "blow a 3/8 hole" in this plate. Meaning;
> "Go drill a 3/8 hole in the plate.
>
> "Dust off." As in "I just "dusted off" the block. Meaning; I
> faced/flycut off a few thou, or just did a bare clean up.
>
>
> --
> BottleBob
> http://home.earthlink.net/~bottlbob
.
- Follow-Ups:
- Re: Machining Slang
- From: What-a-Tool
- Re: Machining Slang
- From: Billy K.
- Re: Machining Slang
- References:
- Machining Slang
- From: BottleBob
- Machining Slang
- Prev by Date: Bitch-slappin the Fadal...
- Next by Date: Re: Hey you Swiss machine d00ds!
- Previous by thread: Re: Machining Slang
- Next by thread: Re: Machining Slang
- Index(es):
Relevant Pages
|
