Re: Make external connector on a USB dongle




"Jeff Liebermann" <jeffl@xxxxxxxxxxxxxxxxxxxxxx> ha scritto nel messaggio
news:u15io1l2pp8fub5jce7534oc37h19a821r@xxxxxxxxxx

> That was also my original suggestion. However, I wanted to take the
> long leads and the filter out of the circuit and connect as close to
> the bandpass filter as possible.

Uhm... today I've realized this:
http://tinypic.com/hvumur.jpg

Ok, it works, but I don't know why... with the previuos modify on my PCMCIA
card, without external antenna the signal was ZERO.
Now, with this dongle, without antenna (the bluechip) I've got signal...
With antenna mounted (a simple rubber D-Link antenna) the signal is not
stronger than without...

I'm ready with 3 attemps.

with antenna connected:
1) at the end of diversity (before the filter)
2) at the end of filter (cutting C3)
3) on the SW1 place (cutting L7 and C33)

Next week I'll receive a R&S powermeter 3GHz capable, and I'll to try in
these 3 positions.
I've also a friend of mine with a Anritsu antenna/power/swr analyzer.
I'll tell you...

Thanks again for support: virtual coffe (italian espresso) payed for you.


.



Relevant Pages

  • Re: GPS GR Correction Myth.
    ... it offers essentially>>zero group delay across ... ... > Wide band antenna, allowing multi channel and digital broadcast. ... The correction filter will have to correct for the combination ... Video group delay pre-correction is utterly irrelevant ...
    (sci.physics.relativity)
  • Re: Issue with antenna causing instabillity
    ... coaxial filter can as used in repeater installations, ... Image response only doubles the ambient noise, ... Did you do the test to see if a small amount of attenuation improves S/N, ... Can I simply retrofit a filter in line with the antenna (The ...
    (rec.radio.amateur.antenna)
  • Re: Phone line as SW antenna [12-Jul-06]
    ... capacitor straight into the receivers antenna connection (doesn't sound ... As a kid I use to lay a radio next to, or a whip antenna against a phone ... A high-pass filter can be used to remove signals below the shortwave ... 100 kHz -120dB ...
    (rec.radio.shortwave)
  • Re: Phone line as SW antenna [12-Jul-06]
    ... capacitor straight into the receivers antenna connection (doesn't sound ... As a kid I use to lay a radio next to, or a whip antenna against a phone ... A high-pass filter can be used to remove signals below the shortwave ... 100 kHz -120dB ...
    (rec.radio.shortwave)
  • Re: help with navtex/medium wave receiver sensitivity and decoding
    ... A lot of the noise at that band is electrostatic, ... my antenna theory is basic so I'm probably missing something... ... reasonable edge detection between a logic 1 and zero. ... I'm trying to resist putting a very tight filter on the front end as I ...
    (sci.electronics.design)