Re: trying to get Intel Pro Wireless 2011 LAN Access Point to work with my XP
- From: "BadMullah" <BadMullah@xxxxxxxxx>
- Date: 18 Oct 2005 22:33:05 -0700
Thanks for reply.
I bought this Access point a week ago
http://www.trademe.co.nz/structure/auction_detail.asp?id=37177979
It is a Intel PRO Wireless 2011 LAN Acess Point
Ex owener says he has been using it with his XP.
There is a S/N at the back with a barcode that says:
000347144EC3
I was going to telnet to it assuming that is an IP address according to
Intel®PRO/Wireless 2011 -Access Point
Product Reference Guide
It says
"Section:Gaining Access to the UI
The method for establishing access to the UI depends on the connection
used. Select the setup that best fits the network environment.
"2.1.1 Using a Telnet session to gain access to the UI requires that a
remote station have a TCP/IP stack. The remote station can be on the
wired or wireless LAN.
To access the AP from the workstation:
1. From the DOS prompt Telnet to the AP using its IP address:
Telnet xxx.xxx.xxx.xxx
2. At the prompt type the password:
Intel
The password is case-sensitive."
but I think that is shorter than an IP address to be telneted...
there is WLAN Utilities in intels website that I have downloaded but
WLan Monitor application says 'An Intel(R) PRO/wirless 2011 LAN adaptor
not found'
Thanks .
.
- Follow-Ups:
- References:
- Prev by Date: Re: Long Range Wireless Antenna
- Next by Date: Re: linking 2 wireless routers
- Previous by thread: trying to get Intel Pro Wireless 2011 LAN Access Point to work with my XP
- Next by thread: Re: trying to get Intel Pro Wireless 2011 LAN Access Point to work with my XP
- Index(es):
Relevant Pages
|