Re: linksys wga54g



Andrew Nisbet wrote:
ok, the manual (ftp://ftp.linksys.com/pdf/wga54g_ug.pdf) mentions the
light should be green, and does not mention an orange or amber led.

It looks like simply pressing the reset button does the factory reset,
i.e. it does not say for how long ... as the .250 is the default
address it may not make a difference,  but worth a try.

Not sure if you can reload the firmware via tftp, it only mentions the
web interface, that might be the problem as is has basic connectivity
vi ip and things seem to go bad (oragne) after some inital tests are run

good luck.

A.

had it confirmed by linksys support that it is a firmware problem. no way of fixing via tftp (which I guessed). pity.
.




Relevant Pages

  • Re: third party firmware
    ... have your computer set to an IP in the same subnet. ... down the device and be ready with the TFTP program. ... Power up the device and ... I have used the tftp and held the reset for a minute or two. ...
    (alt.internet.wireless)
  • Re: Cannot recover password PIX 501 - TFTP Failed (return:-10 arg:0x1)
    ... far been unable to reset the password using the password recovery ... TFTP failed ... have permissions to be read by the tftp server process ...
    (comp.dcom.sys.cisco)
  • Re: Upgrading DD-WRT Firmware - Clear settings or not?
    ... to a new version via the web interface or TFTP. ... recommended that you restore the router to defaults using the reset ...
    (alt.internet.wireless)
  • Re: Axim Update
    ... I am pressing the power button. ... While holding the power button down, ... while I do the reset just to see if anything else happens. ... I have hard-reset this axim probably over 30 times in the past few ...
    (microsoft.public.pocketpc)
  • Re: How to reboot a computer immediately by programming?
    ... Doesn't work in windows. ... Is this cold boot efficiency equivalent to pressing the RESET button, ...
    (comp.lang.asm.x86)