Re: feet
On Tue, 26 Jul 2005 13:28:29 +1000, dAz <dazb@zipDOTcomDOTau> wrote:
>Jim Bianchi wrote:
>> Exactly what happens when I back out the dial feet screws? And if I
>> do, will the dial just fall out with the movement still in its case? (This
>> is an OF case, remember.)
>>
>
>you only need to undo them enough to free the dial, the threads should
>be long enough for the screws to stay in the plate.
>
>the dial will just lift off, remove the hands first but. ;)
>
LOL.
Cut the green wire.
Now cut the brown wire.
Splice into the blue wire and connect it to the white wire.
Now you can safely cut the red wire.
..
..
..
But before you do all that... hello, HELLO !!?
--
Regards, Frank
.
Relevant Pages
- Re: Cleaning copper wire
... >I need a good way to clean the oxides off copper electric wire. ... >solder splice? ... terminals, though I presume that they existed at one time. ... requires terminals with thicker insulation. ...
(rec.crafts.metalworking) - Re: Wiring in conduit
... Does code allow me to have a splice within the conduit? ... I would rather not pay for a new roll of wire when I'm only shy ... I wouldn't recommend a spliced connection in conduit. ... It may make it more difficult to pull the wire through ...
(alt.home.repair) - Re: OT A rotten day.....(misbehaving student/metal/tool rant)
... | on the bench with no way to get it onto the wire other than undoing the ... There's a splice we called "Belden Braid" using ... continue the sleeving, rather than solder sleeves. ... | and then push the two ends together so the strands intertwine, ...
(rec.crafts.metalworking) - Re: Electrical Question
... Doug Miller wrote: ... trace the wire and had a problem. ... homes -- and obviously much more difficult than repairing a failed splice. ... And you have to run it today, not someday ...
(alt.home.repair) - Re: Further to power over steel wire.
... Yes, good point, I will put 4 mm copper wire jumpers ... solder all the splice points - or even 60/40 lead/tin solder if you ... The splice joints are probably already too corroded and dirty to solder, ... Another reason to prefer AC is to reduce corrosion. ...
(rec.crafts.metalworking) |
|
